Is it possible to do an source call-Routing (ANI) on an Cisco IOS Gateway ?

clachman · ‎12-05-2003

Hi,

i´ve the following Problem. I want to route an Call from the PSTN over an IOS Gateway to another Gateway by using the Calling Number (ANI). The Called-Number is allways the same but the Calling Number is different. The IOS-Gateway should route the Call by the Different Calling Number (ANI) not by the Called Number. I tried some tests with IOS 12.2.11T10 but i wasn´t able to route the call properly.

Is there a solution avalaible where i can route the Call on an VoIP-Dial Peer properly ?

Thanks

Carsten

fbadr · ‎12-10-2003

configure the dial-peer with the command :

answer-address "The Call Destination Number"