Is it possible to do an source call-Routing (ANI) on an Cisco IOS Gateway ?
i´ve the following Problem. I want to route an Call from the PSTN over an IOS Gateway to another Gateway by using the Calling Number (ANI). The Called-Number is allways the same but the Calling Number is different. The IOS-Gateway should route the Call by the Different Calling Number (ANI) not by the Called Number. I tried some tests with IOS 12.2.11T10 but i wasn´t able to route the call properly.
Is there a solution avalaible where i can route the Call on an VoIP-Dial Peer properly ?
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...