I have a 7206VXR with NPE400. I have one T1 connected to 4/0 and a quintum D3000 connected to 4/3, the quintum should received the call and route it to RADIUS Server. All these circuit are up and sync. The problem is when I tried to make a call, it gets busy "Ciruit/Channel not available". And it does event reached the D3000, I don't see any logs on it, that shows a call coming from the VXR. Below is my dial peer and I will post the debug messages on the next post. Am I missing something on the configuration in the VXR side ? Hope you could help me find a resolution to this problem.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...