Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

message ss7

We have already the configuration of the AS5400 and PGW2200 with ss7 and the PSTN and PLMN;

assigning a trunk of channels for different clients. In this way, we configure a trunk with

just 2 channels to the PLMN, but the error happen for the third simultaneous call, because

we listen the next message from the PSTN: "... the number you dial don't exist, plesase

try again...." we are looking for a message like a busy tone or a congested network message.

Please support us.

I attach a file with the log obtained from the ss7 analyzer between PSTN and PGW.

Thanks in advance

1 REPLY
Bronze

Re: message ss7

If your DN is in VACANT state it shows a typical announcement “"The number you dialed is not in service. Please check the number and try again." The cause code for this state is #1.There must be a problem with the configuration of call routing.

144
Views
0
Helpful
1
Replies
CreatePlease to create content