Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Modem Pass through to remote PBX

Dear All,

I would like to use the cisco router 3640 (with T1 card) and cisco 2621 (with 2 x FXS card) to simulate the network & pstn environment to test the modem pass through, here is the detail connection:

Analog Phone (Ext: 451660) <--> [FXS] Cisco Router 2621 <---- LAN ----> Router 3640 [T1] <--> [T1] PBX (Panasonic) <--> Analog Phone (Ext: 454820, Modem)

The dial-peer on the router 2621 & 3640 is working as I can call in/out from PBX analog phone, and I was success to connect the PC (with modem port, and use the hyperterminal, atdt454820) from Outside PC (with modem port, Ext: 451660).

But I was fail to dial-out from PBX analog phone (454820) to 451660.

From Cisco router 2600:

dial-peer voice 45166 voip
destination-pattern 45166.
modem passthrough nse codec g711ulaw redundancy
session target ipv4:192.168.0.60 (Router 3640)

From Cisco router 3640

dial-peer voice 454820 voip
destination-pattern 454820
modem passthrough nse codec g711ulaw redundancy
session target ipv4:192.168.0.44 (Router 2600)

Here is the link I try to follow to do:

http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dtmodptr.html

I would like to know if there is any miss-configure or how can I troubleshoot (to find out the cause) which I cannot connect from PBX' PC.

Thanks!

Everyone's tags (2)
1 REPLY
Cisco Employee

Re: Modem Pass through to remote PBX

Note that anytime a call traverses a voice gateway, we match *two* dial-peers, not one.  We match one inbound, and one outbound.  In your scenario, if the FXS side originates the call, it would be:

fxs(inbound pots)router(outbound voip)----LAN-----(inbound voip)router(outbound pots)---T1

The algorithm for how this works is documented in this link.  I recommend having a few reads over this:

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

If you can get these debugs, I can take a deeper look into the failure:

debug voip ccapi inout

debug isdn q931

debug vpm sig

debug h225 asn1

debug h245 asn1

Collect these in the following manner:

Router(config)# service sequence
Router(config)# service timestamps debug datetime msec
Router(config)# logging buffered 10000000 7
Router(config)# no logging con
Router(config)# no logging mon
Router(config)# voice iec syslog

Router# term len 0

Router# sh logg

Also send the full configs of both gateways.

-Steve

805
Views
0
Helpful
1
Replies