Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multiple E1 and CCME

I have a question about CCME 4.0 and multiple E1 connections.

In my configuration, I have two E1 connections each with their DID numbers. I am assuming that I will need a VOIP dial peer for each with the appropriate port 0/1/0:15 for the first E1 and port 0/2/0:15 for the second E1.

My question is about outbound calling, and does CCME able to use both to pots dial peers? Is there a way to have a route group as in CCM? Or do I have to have translation profiles built so that I can "split" the outbound calls dependent on the VOIP phone calling outbound?

Thanks

Dennis.

1 REPLY
New Member

Re: Multiple E1 and CCME

Dennis,

You can create a trunk group to bundle the voice ports ports together. See the various trunk group commands beginning here:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a00800b3511.html#wp1500903

Phil

136
Views
0
Helpful
1
Replies