Hy guys, I have this problem with one of clients, he is sending a call to my cisco AS5300, the call is getting translated well, and goes out to the other switch where it has to get billed, but on another switch the calling number is comming wrong or empty, than the billing does not recognieze it. and rejects the call. this is the config.
voice translation-profile hyphenin
translate calling 6300
translate called 63001
dial-peer voice 6300 pots
translation-profile outgoing hyphenin
and this is the call log,
as you see the calling number is abc12345
I tried to send the call to the cisco without abc, only the 12345, and
it worked well, so now I asked that client to change he's calling number
but he cannot do it. in he's device.
i need some how to make sure that any calling number wich comes in with letters like abc or some
like that, get stripped and so that the call gets translated normal, and
send further to the other switch .
Jul 28 13:03:22.031: %SYS-5-CONFIG_I: Configured from console by alp on vty1 (82.xxx.xxx.125)
Jul 28 13:03:32.223: %ISDN-6-CONNECT: Interface Serial0:8 is now connected to unknown unknown
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...