I am seeing some funny behaviour and wonder if anybody can throw some light on this. I have a 3640 running a late edition 12.4 IOS. The system has a NM-2V with a vic-2fxo fitted. If I connect 2 lines to the card then port 0 rings on port 1 and port 1 does not ring. I have tried every combination I can find but cannot get the port 0 to ring on port 0 or port 1 to ring at all.
I have set up with 2fxo cards and can get both cards to show this behaviour at the same time, have swapped cards out and tried other versions of the IOS.
Anybody else seen this and know what is happening?
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...