Hi, I have installed 2 NM-HDV with 5 PVDM-12 to each on 3725. I wonder if this is normal (I try on all 12.4 IVS IOSes and all the same behavior):
When the 3725 boot up, it will show "changed state to up" for DSP 1-10 when I have 5 PVDMs, 4-15 when I have 4 PVDMs, 7-15 when I have 3 PVDMs.
The question is why the booting never show all 15 DSPs in the 5 PVDMs (just 1-10)? This happens to both of my NM-HDVs, so unless both NM-HDVs are defective, they should not behave the same way, or maybe my 3725 cannot handle all the DSPs there?
Anyone have the same experience?
When I have a show diag, I do see all the HDV SIMMs listed:
High Density Voice Port adapter
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware Revision : 1.1
Top Assy. Part Number : 800-03567-01
Board Revision : G0
Deviation Number : 0-0
Fab Version : 02
PCB Serial Number : JAB05400BWQ
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : NM-HDV=
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 00 CC 41 01 01 C0 46 03 20 00 0D EF 01
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...