Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Busy Tone in One Direction

Hi,

Currently I'm having a problem with my voip setup because i don't get busy tone in one direction. I run some debugs like the debug isdn q931 and h225 ans1 and test a good call and bad call. Below is my call flow;

Bad Call:

Phone1(2115)--PBX----ISDN Link-------Bugo-------H323 link---------Fort------ISDN

Link------PBX--Phone2(1994:in use)

Good Call:

Phone1(1991)--PBX----ISDN Link-------Fort-------H323 link---------Bugo------ISDN

Link------PBX--Phone2(2142:in use)

Attached were my debugs output.I hope someone can help me.

Many Thanks,

Reymon

2 REPLIES
Silver

Re: No Busy Tone in One Direction

A Cisco IP phone (CallManager scenario) or Plain Old Telephone Service (POTS) phone (VoIP Toll-Bypass scenario) does not hear a busy tone or announcement message from the PSTN network. This symptom applies for both VoIP Toll-Bypass calls and IP phone to PSTN/PBX calls. The problem may occour when Cisco VoIP routers/gateways exchange signaling capabilties with the telco switch.

New Member

Re: No Busy Tone in One Direction

Hi Wong,

Do you mean that there is a problem with my signaling between the Cisco router gateway and PBX?. i'm using both isdn switch-type primary-net for the voice port configure in router. Also im just getting this no busy tone in one direction.

Please advised!

Thanks!

Reymon

232
Views
0
Helpful
2
Replies