Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

not all my outbound calls g.711?

hi

have added a new region device pool etc to callmanager..have noticed on some of my new phones that some of the outbound calls show up as g.711 which is correct and other as g.729..not sure why this is as new gateway is in same device pool as new phones and callmanager is set to use g.711 within this region and g.729 to other regions..feel its something on the gateway or am i missing something

1 REPLY
Bronze

Re: not all my outbound calls g.711?

Sometimes some calls don't match any configured dial-peers and use default dial-peer. Default dial peer always uses g729.

Also, it is possible that remote phone configured for g729 region uses your gateway for outbound calls.

useful commands:

show voice call status - shows which dial-peers are matching.

show call active voice id - shows complete information about the call

146
Views
0
Helpful
1
Replies
CreatePlease to create content