Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Only class-default supported over FR VCs?????

Hi friends,

When I apply a "class" over a frame-relay subinterface i obtain the nex error message: Only class-default supported over FR VCs..

I am implementing a QoS feature on my routers.

Regards

1 REPLY

Re: Only class-default supported over FR VCs?????

You will need to use a hierarchical service policy. As stated in the following document, "You must create a default class for the service policy as specified with the class class-default command to configure FRTS using MQC on a Frame Relay PVC." The following link should help.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080110bc6.html

Hope this helps. If so, please rate the post.

Brandon

148
Views
0
Helpful
1
Replies