Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PBX & Router E&M integration

My Head office PBX is connected to my Voice Router with 6 (VIC2-2E&M x3 card) E&M Port and my Remote office is the same. Both routers are connected through fiber.

My requirement is:

1. HO dial to access code 60, then get a second dial tone and dial RO PBX number (3000-3500)

2. RO dial to access code 70, then get a second dial tone and dial HO PBX number (2000-2500)

My router config is below:

HO config:

voice-port 0/0/0

description ** E&M-1***

type 5

signal immediate

timeouts call-disconnect 3

connection Tie-line 60

dial-peer voice 1 pots

destination-pattern 70....

port 0/0/0

dial-peer voice 60 voip

destination-pattern 60....

session target ipv4:172.16.1.2

RO config:

voice-port 0/0/0

description ** E&M-1***

type 5

signal immediate

timeouts call-disconnect 3

connection Tie-line 70

dial-peer voice 1 pots

destination-pattern 60....

port 0/0/0

dial-peer voice 70 voip

destination-pattern 70....

session target ipv4:172.16.1.1

Please tell me that, this configuration is OK or not ?

166
Views
0
Helpful
0
Replies
CreatePlease to create content