We have migrated from CCM4.1.2 to 5.1.2. As Personal Directory is now incorporated within CCM5 and is not a service anymore as in CCM4, how do we specify predial digit to be applied to the directory and fast dial entries as they dial out?
There is a "PreDial" parameter for the PAB and Fast Dials services that is added by the administrator, and the default
value should usually be set to 9. Whatever the PreDial parameter is set to gets prepended to all numbers appearing in the PAB and Fast Dials where the number of digits is more than 7. If you are going to enter someone's long distance telephone number then you should put a 1 at the front of the digits, and then the 9 will be prepended to that.
In CCM 5.X, PAB and Fast Dials are not using Services anymore, but rather could be found under Directories/Personal Directories button. When we migrated from 4.X to 5.X, all entries were migrated, except for the predial digit specified in the 4.X Services.
IntroductionPre-requisite: Caveat :When IPXE Boot could be done : IPXE Boot :Ipxe boot using DHCP Server :
iPXE boot in ASR9K
Migration recommendation document for Cxr to Exr.
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...
Hi community,I just wanted to share my findings about accesing to ACL counters by SNMP on ASR9000/XR.
Searching on Internet I found the section ACL Counters Using SNMP in the IP Addresses and Services Configuration Guide but I didn't found any inf...