Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PGW & 5400 bearer configure

we had successfully configure PGW+SLT2651XM+L.Switch, L.Switch & PGW can communicate[rtrv-tc:all, shows active cic].

SLT uses drop/insert, and it is configured to supply a trunk [E1] to AS5400

We need to configure signalling bet. PGW and 5400AS box.

1-as you know there are many implemenation, so i want to know which best fit the mentioned solution

2- if i choose to use PGW in signalling mode, should AS have a PRI E1 [not CAS]

3- in case of nailed [call control] configuration in the 5400 side

2 REPLIES
New Member

Re: PGW & 5400 bearer configure

Hi,

It is not very clear what exactly is the solution.What you want to do is not understandable with just showing the connected devices.

And signaling mode and nailed mode are the same thing.

You can eiter configure PGW in signaling (just translate SS7 to IP signalisation) or in Call Controll mode.

Please provide more info to get an answer.

Best Regards,

Teo

New Member

Re: PGW & 5400 bearer configure

really i want to configure the signalling bet. PGW and AS5400 [PGW side and AS site]. any detailed info you need, i will provide, please just ask.

attached SLT configuration

142
Views
0
Helpful
2
Replies
CreatePlease login to create content