11-29-2007 06:06 PM
Hi all,
I have a solution that connect 2 pgw's with one as5400, the TDM switch that have ss7 are connected to the as5400, and they use the TS 1 for signaling, I have configured my as5400 e1 as follow:
controller E1 1/0
framing NO-CRC4
pri-group timeslots 1-31 nfas_d primary nfas_int 0 nfas_group 0 rlm-group 0 !
interface Serial1/0
no ip address
!
interface Dchannel1/0
no ip address
encapsulation hdlc
isdn incoming-voice modem
no isdn send-status-enquiry
isdn negotiate-bchan resend-setup
no cdp enable
!
My questions are 2:
1.- how to change the ts 1 to be used for signaling mode instead of use 16?
2.- I'm using nailed mode, so, do I have to create all trunks in my pgw? and also have to create my d channels in the pgw?
Hope that you can help me
Regards
12-03-2007 11:35 AM
You will need to create a channel group for TS1 since this is considered and integrated SLT setup:
http://cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00800b6ab9.html
Hope this helps
12-08-2007 04:32 AM
The reply of Crieman was obviously useful, so I vote for it instead of the guy who asked the qusetion.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: