Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PGW and ITP

Did anyone succesfully connect cisco PGW and ITP as M3UA? I was working by the book but still getting error in INIT state "SCTP: Unknown INIT param 49152".

Any help would be appreciated.

Regards,

Ivan

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: PGW and ITP

Hi,

I am attaching a working configuration of the PGW(9.5.2) and ITP. It has been implemented and working nicely for several months at an operator's site.

There are two ways to operate the ITP:

-Signaling gateway mode: the OPC is shared between the PGW and the ITP

-STP Mode: there is a different PC on the PGW and the ITP and the ITP behaves like an STP

The configuration attached reflects the first mode. To use the second mode just change the PC and add the routes.

To avoid complications, I have stripped the rest of the configuration which involves instances and ITP pairs.

I hope this helps,

Marc

5 REPLIES
New Member

Re: PGW and ITP

Hi Ivan,

Well i hit a bug a while back. Check it out: CSCdy40025

regards

Venky

New Member

Re: PGW and ITP

Hi,

that bug note says that router crashes in the proces. My router is ok, just i unable to create connection to pgw (it even sends INIT_ACK after ERROR) but then again starts INIT.

Do you have a working configuration with pgw? Could you share it with me?

New Member

Re: PGW and ITP

Hi,

I am attaching a working configuration of the PGW(9.5.2) and ITP. It has been implemented and working nicely for several months at an operator's site.

There are two ways to operate the ITP:

-Signaling gateway mode: the OPC is shared between the PGW and the ITP

-STP Mode: there is a different PC on the PGW and the ITP and the ITP behaves like an STP

The configuration attached reflects the first mode. To use the second mode just change the PC and add the routes.

To avoid complications, I have stripped the rest of the configuration which involves instances and ITP pairs.

I hope this helps,

Marc

New Member

Re: PGW and ITP

Marc,

thanks a lot. I'll try that config.

Regards,

Ivan

New Member

Re: PGW and ITP

Marc,

I am wondering if you would still have the config posted for this rip. I have worked with SLT for PGW in the past...I am now working on an ITP-L, basically the same...but some syntax has changed...

I will be running 9.6(1) code for the PGW. Running nailed mode for the ITP-L. I have noticed that the ss7 syntax applicable to the 2600 series SLT is gone for 2811 ITP.

I am curious applicability of your config. I will be running 2 PGWs for redundancy.

David

224
Views
0
Helpful
5
Replies
CreatePlease login to create content