Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PGW howto suppress hop-count for ISUPV3

i have tried to add the hopon property to the trunk-group profile but this property seems to be only available for ANSI-SS7 and not ITU. how else can i suppress this property which is being sent out in the IAM message after arriving from SIP?

Leon

1 REPLY
Bronze

Re: PGW howto suppress hop-count for ISUPV3

Hopon seems to be only available for ANSI-SS7 and not ITU as you have mentioned. When configuring a profile, you can attach a profile to a signaling service, but both the profile and the signaling service must belong to the same variant. However, you can create a profile even though the signaling service does not exist. While configuring the profile disable the hopon feature which will suppress this property.

A profile allows one or more properties to be set once and then reused multiple times. To create a profile, use the PROV-ADD command as follows:

mml> prov-add:profile:name="profile1",type="grprofile",hopon="0"defaultBC="3_1_KHZ",

confusion="1"

128
Views
0
Helpful
1
Replies