Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PGW reboot for machine and services ..............?????????????...........

Hello,

any body can tell me how can:

1. Reboot PGW as machine (Totally reboot)

2. Service rebbot only

please can show the commands and steps.

thank you for any help.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: PGW reboot for machine and services ..............??????????

1) /etc/init.d/CiscoMGC stop

reboot

2) /etc/init.d/CiscoMGC stop

/etc/init.d/CiscoMGC start

2 REPLIES
Cisco Employee

Re: PGW reboot for machine and services ..............??????????

1) /etc/init.d/CiscoMGC stop

reboot

2) /etc/init.d/CiscoMGC stop

/etc/init.d/CiscoMGC start

New Member

Re: PGW reboot for machine and services ..............??????????

ok thank you.

i have now this issue:

i need to add new E1 to be in the same trunk for previous E1 which is for Abdali. new E1 will not have signal it depeneds at old one timeslot.

i used this for new E1:

prov-add:nailedtrnk:name="1033",srcsvc="ss7p-jtc-abdali",dstsvc="naspath1-abdali",srcspan="ffff",dstspan="0",srctimeslot="33",dsttimeslot="33",spansize=31

for old one this:

prov-add:nailedtrnk:name="1002",srcsvc="ss7p-jtc-abdali",dstsvc="naspath1-abdali",srcspan="ffff",dstspan="0",srctimeslot="2",dsttimeslot="2",spansize=30

============================

at AS5400 i used to add new E1:

controller E1 7/2

framing NO-CRC4

pri-group timeslots 1-31 nfas_d primary nfas_int 1 nfas_group 0

Is this true or there are other commands i should use?

----------------------------

OLD E1 is configured as:

controller E1 7/0

framing NO-CRC4

channel-group 0 timeslots 1

pri-group timeslots 2-31 nfas_d primary nfas_int 0 nfas_group 0

description Connection to Abdali

interface Serial7/0:0

no ip address

encapsulation ss7

channel-id 0

!

interface Serial7/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-ni2c

isdn incoming-voice modem

isdn map address . plan isdn type network

isdn rlm-group 0

no isdn send-status-enquiry

isdn negotiate-bchan resend-setup

isdn bchan-number-order ascending

no cdp enable

any help please for correct commands i shall use? please see attached file for details

154
Views
0
Helpful
2
Replies