PGW - routed IAM looses part of the 'User Service Information' Element
I have PGW 9.3(2) with two AS5350 configured both for termination of IMTs and used as SLT (two E1 links with channel 16 used for SS7 signaling). The PGW is not in nailed mode, but in call-routing mode.
The test I made is very simple - making a call from one side (TRG1001) which is routed to the other side (TRG1004).
I capture the messeges at both sides and see that part of the service information like for example 'User rate - 9.6 kbit/s, V.6 and X.1' and many others are loosed.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...