I need your help to configure my voice setup.I have two location connected with a point-to-point leased line. Both the ends have different brand pbx installed. One is connected with R1 with the help pf a T1 voice card and Other is connected with R2 with the help of a E1 card. I am giving an attachment of the scnerio. Please help me to configure the cisco 3640 routers with H.323 gateway. I will be very thankful to you.My bosses has given me this work to do. Now I need your help. I have some exerience to configure E1 and T1 cards also have some knowledge of configuring dial pears.
One caveat to this document is what you stated above, one side connected via T1 and one side connected via E1. This might not be possible due to PBX limitations. You are going to want to research the blurb below to see if you can do this.
A connection trunk T1 CAS to E1 CAS mapping does not work by default. Bit-order manipulation on the gateways must be performed and may not always work, based on the PBX support of various ABCD bit signaling.
Can I connect a T1 cas with a E1 pri Line. Please give me some detail.
Actuly the calls are going back and forth.But the problem is that we are not getting calling party numbers on over phones. I am going to give the router configuration which is allready done. I suspact that it is a wrong configuration.But I know u are the people Who can help me to Solve the issue.
Ok, this was the 2nd thing I was just about to recommend, and that was to not Trunk due to the E1/T1 limitation and just terminate and route everything H323. Both sides are CAS, just one is E&M Immediate and the other is R2-Digital. Unlike the 1st document I linked you are not trunking the connections you are using a PLAR to a voice-port. Essentially you are using a H323 dialplan to do this in a limited fashion.
Unfortunately CAS doesn't support ANI unless you use FGD or FGD-EANA on the T1 side Router and PBX. Not totally sure on the R2 side but I believe you need to configure your PBX and R2 router to use R2-Digital Compelled, non-compelled or semi-compelled to get ANI information on that side.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...