I am using an AS5400 as a voip gateway to PSTN. It is connected to a softswitch via an ISDN PRI. The caller id name is not being passed from the softswitch in the ISDN message. Is there a particular setup for the ISDN I need to enable this?
The link did shed some light on the subject. I still can't find any answers. We are in the process of learning more about our softswitch too so we don't know what if anything is being sent over the PRI. I am checking with Cisco to see if the IOS were running even supports cnam over the ISDN.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...