cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
372
Views
0
Helpful
2
Replies

Problem integrating service Providers Voice link (E1) with AS5300 Gateway

chuks
Level 1
Level 1

Scenerio:

I have a cisco Callmanager integrating with an AS5300 PSTN Gateway on my network, am currently trying to integrate an E1 (direct Connect) for voice, from a service provider so as to route outgoing calls from my network through them.I have a challenge of been able to display my caller id on the receivers end, instead of the pilot number given to me by th provider.

e.g If I place a call from any extension on my network say 1652, i expect to see

0808926(1652) on the receivers end, but instead the pilot number from the service provider 0808926(0000)is displayed on the receivers set.

How can i resolve this issue? the service provider uses an Ericsson AXE 810

2 Replies 2

teodorgeorgiev
Level 4
Level 4

Run a "debug isdn q931" on the Cisco (apply it on the outgoing interface) and post it here.

paolo bevilacqua
Hall of Fame
Hall of Fame

You need to use route mask on the CCM, please report in "ip telephony" to receive a more detailed answer, or search the forum.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: