Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem integrating service Providers Voice link (E1) with AS5300 Gateway

Scenerio:

I have a cisco Callmanager integrating with an AS5300 PSTN Gateway on my network, am currently trying to integrate an E1 (direct Connect) for voice, from a service provider so as to route outgoing calls from my network through them.I have a challenge of been able to display my caller id on the receivers end, instead of the pilot number given to me by th provider.

e.g If I place a call from any extension on my network say 1652, i expect to see

0808926(1652) on the receivers end, but instead the pilot number from the service provider 0808926(0000)is displayed on the receivers set.

How can i resolve this issue? the service provider uses an Ericsson AXE 810

2 REPLIES

Re: Problem integrating service Providers Voice link (E1) with A

Run a "debug isdn q931" on the Cisco (apply it on the outgoing interface) and post it here.

Hall of Fame Super Gold

Re: Problem integrating service Providers Voice link (E1) with A

You need to use route mask on the CCM, please report in "ip telephony" to receive a more detailed answer, or search the forum.

154
Views
0
Helpful
2
Replies