Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem on VIC2-2BRI-NT/TE Sometimes Can´t make calls

I have configured this card, and some times Cant receive calls and some times can´t make calls, and to make calls again just receive a call, and now can make calls for little moment. What can be the problem?

interface BRI0/2/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn send-alerting

isdn sending-complete

isdn static-tei 0

!

voice-port 0/2/0

compand-type a-law

cptone MX

dial-peer voice 100 pots

destination-pattern .T

direct-inward-dial

port 0/2/0

forward-digits all

!

dial-peer voice 3 voip

destination-pattern .T

progress_ind setup enable 3

voice-class codec 1

session target ras

ip qos dscp cs5 media

ip qos dscp cs5 signaling

!

3 REPLIES
New Member

Re: problem on VIC2-2BRI-NT/TE Sometimes Can´t make calls

Try "no dial-peer outbound status-check pots" in global configuration mode.

Regards,

Ivan

New Member

Re: problem on VIC2-2BRI-NT/TE Sometimes Can´t make calls

I have tried it and really worked, thanks a lot of

New Member

Re: problem on VIC2-2BRI-NT/TE Sometimes Can´t make calls

Well, you could rate my post if it was helpful ;-).

Ivan

120
Views
5
Helpful
3
Replies
CreatePlease login to create content