Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS apply problem

Hi friends,

I have this QoS configuration:

class-map match-all FTP

match protocol ftp

policy-map limitFTP

class FTP

shape average 1000000

policy-map parent

class class-default

service-policy limitFTP

map-class frame-relay test

service-policy output parent

interface serial1/2

frame-relay traffic-shaping

interface frame-relay 1/2.X

frame-relay interface-dlci X

class test

When I apply the last command ( class test on the sub-interface) I have this error:

GTS: Can be enabled only at the first level.

What is this? Can someone help me?

Thank you very much

1 REPLY
Bronze

Re: QoS apply problem

Raul:

GTS is generic traffic shaping. It can be configured on the interface or subinterface.

Class looks like a verification command from global config mode.

Check here for details on how to configure, and commands that may assist in what you are attempting.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800bd8f0.html

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800bd8ef.html#wp1000902

Hope that helps.

Tom

140
Views
0
Helpful
1
Replies