I have never configured QOS for voice traffic. We have 2 PBX connected through ip connection, and we are using analog phones.I have discovered some latency in phone calls. There is no QOS configuration done for Voice on edge switches.
Can somebody provide me with configuration examples how to get Voice traffic prioritized over other data traffic?
It contains a section for each Catalyst switch type and how to configure it for VoIP and data QoS. Other than that you could also read through the QoS section of your Catalyst and IOS specific configuration guide.
If you have problems finding it let me know your Switches and IOS versions and I will point out the relevant link.
As you are only talking about VoIP: "auto qos voip" might be the right command on most switch ports. Details and additional options are again described in detail in the above mentioned document.
If you do have further questions, do not hesitate to aks.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...