Question about 2811 gateway and creating transcode channel without SIP
I also posted this at IP telephony but I think this is better place to ask this type of questions.
Is there a way to nail up an IP to IP transcode channel through a 2811 without any SIP (or other) signalling by using IOS commands? I'd like to stream IP media through the gateway using test equipment that cannot perform the SIP signalling. The alternative is to hook up a few endpoints, start a sip session to open up the media ports. unplug the endpoints and turn on the test equip to stream the media. However, I'm not sure there is any keep alive that might kill the session after some interval of inactivity.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...