I have an AS5400 router and it sends voice traffic to "provider E". There are 16 T1 circuits (6/0 - 6/7 and 7/0 - 7/7) to "provider E". The config is
dial-peer voice 44001 pots
description, provider E, 6/0
If the destination is invalid, the router will keep on trying to another T1 circuits. detail pls see the log. How do I configure the router so that it retry 2 or 3 times only? any sample config? thanks
Hi, considering the information I gave is 100% correct, I think the low rating given to my post is quite unfair. Not to mention the many times you've asked similar question always receiving timely responses.
While hoping you attitude toward professionals will improve, which you good luck.
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?