Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

RSP reload with QoS application

Hello,

we are working with a 7513 with 12.2(6a). We were applying the

service-policy and FRF.12 to several sub-interfaces and sudden the

router rebooted. I am wondering if it could be due to the memory leak

in VIP2-50. Has someone had some similar experience ?

The sh diag about the VIP is below.

Thanks,

Cleber

Slot 6:

Physical slot 6, ~physical slot 0x9, logical slot 6, CBus 0

Microcode Status 0x4

Master Enable, LED, WCS Loaded

Board is analyzed

Pending I/O Status: None

EEPROM format version 1

VIP2 R5K controller, HW rev 2.02, board revision A0

Serial number: 08217684 Part number: 73-2167-04

Test history: 0x0E RMA number: 00-00-00

Flags: cisco 7000 board; 7500 compatible

EEPROM contents (hex):

0x20: 01 1E 02 02 00 7D 64 54 49 08 77 04 0E 00 00 00

0x30: 50 00 00 01 00 00 00 00 00 00 00 00 00 00 00 00

Slot database information:

Flags: 0x4 Insertion time: 0x2354 (7w1d ago)

Controller Memory Size: 32 MBytes DRAM, 4096 KBytes SRAM

PA Bay 0 Information:

Mx Serial PA, 4 ports

EEPROM format version 1

HW rev 1.14, Board revision A0

Serial number: 21194548 Part number: 73-1577-07

1 REPLY
Cisco Employee

Re: RSP reload with QoS application

It's probably best to open a TAC case to track crash issues.

It is possible to get some general cause information (hardware vs. software) by looking through "sh ver" and "sh stack".

Regards,

Clay

162
Views
0
Helpful
1
Replies
CreatePlease to create content