Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Securing SIP Trunk

I have a 3845 with 2 ISDN PRA interfaces running as a PSTN gateway. Customers running various PBX systems connecting to this gateway via SIP trunks. I want certain calls from a specific customer go outof a specific PRA. I achieve this by checking 'calling-number' with the 'answer-address' command. But problems arise when the calling numbers are not presented correctly as calls will go out the wrong PRA interface. Is there a way to check both calling-number and source IP address to route the calls?

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Securing SIP Trunk

Yes, that is called carrier-based routing and is a bit complicated to configure. See:

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t11/feature/guide/ftgwrepg.html

Note, only a portion of the above document is applicable to your case.

Hope this helps, please rate post if it does!

2 REPLIES
Hall of Fame Super Gold

Re: Securing SIP Trunk

Yes, that is called carrier-based routing and is a bit complicated to configure. See:

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t11/feature/guide/ftgwrepg.html

Note, only a portion of the above document is applicable to your case.

Hope this helps, please rate post if it does!

New Member

Re: Securing SIP Trunk

Hi Paolo,

This looks like the document I am looking for.

Thanks a lot.

322
Views
0
Helpful
2
Replies