Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

select pri

Hi,

we config 16 pri of the as5400. all of them are both way (in/out).

how do we config the inbound call from serial 6/0:23, 6/1:23, 6/2:23 ......

for the outbound call, it is from serial 7/7:23, 7/6:23 .....

please advice.

Best regards

1 REPLY
Hall of Fame Super Gold

Re: select pri

You cannot control inboud order as it is dictated by the conncted device, not the router.

For outbound, you associate the interfaces in a same trunkgroup with different precedences.

interface x/y:D

trunkgroup

Hope this helps, please rate post if it does!

105
Views
0
Helpful
1
Replies