Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

selecting dial peer based on the ip address of the incoming leg

hello all

i have configured 2 dial peers. i want to select dial peer 1 one the call comes from 1.2.3.4 and select dial peer 2 when the call comes from 3.4.5.6 i am not sure how to search for the same on the internet. please can anyone help me out with this..

2 REPLIES
Silver

Re: selecting dial peer based on the ip address of the incoming

Community Member

Re: selecting dial peer based on the ip address of the incoming

HI

You can use voice source group feature with ACL and some prefixes, Below is an example of such an configuration..

access-list 1 permit 1.2.3.4 0.0.0.255

access-list 2 permit 3.4.5.6 0.0.0.255

voice source-group 1234

access-list 1

disconnect-cause invalid-number

translation-profile incoming 1

voice source-group 3456

access-list 2

disconnect-cause invalid-number

translation-profile incoming 2

voice translation-profile 1

translate called 1

voice translation-profile 2

translate called 2

voice translation-rule 1

rule 1 /^1\(.*\)/ /81\1/ type any subscriber plan any isdn

voice translation-rule 2

rule 1 /^1\(.*\)/ /71\1/ type any subscriber plan any isdn

dial-peer voice 1 voip

destination-pattern 8T

dial-peer voice 2 voip

destination-pattern 7T

rgds,

Ismo

146
Views
0
Helpful
2
Replies
CreatePlease to create content