Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

service-policy output voice-only

Hi, when i enter "service-policy output voice-only" in int BVI1 on a Cisco 878 (G.SHDSL), it throws an error saying, "Class Based Weighted Fair Queueing not supported"

Can i put this line in int ATM0 ?

3 REPLIES
Hall of Fame Super Gold

Re: service-policy output voice-only

Hi,

It should be done as follows:

Remove BVI and "bridge irb". Configure an ATM subinterface point-to-point with the IP address, "atm route-bridging" and PVC. Under PVC apply the service policy.

please rate post if it helps!

New Member

Re: service-policy output voice-only

Hi Bevilacqua,

Thanks so much for replying so quickly.

Can i post the configs here ?

Hall of Fame Super Gold

Re: service-policy output voice-only

Hi,

I understand the config that you have now.

Make the suggested changes and if doesn't work, then post modified config.

305
Views
0
Helpful
3
Replies