I'm trying to setup an h.323 gateway on a 2621XM router with an FXO port. I think I have everything configured right on CallManager and on the router, but my call never goes out. The phone accepts the number I dial, but it just goes to dead air and then says "Call Proceed" on the phone. Here's the config on my router:
dial-peer voice 4 pots
description FXO Port 1/0/0 local calling
When I dial the FXO port from outside, it dials then I get dial tone when it picks up. What I would like to do (once I get it to dial out!) is send all incoming calls to a DN on an IP phone. Thanks!!
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application Engineered...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?
Cisco Software Manager Server
This document describes the programmatic interfaces, RESTful APIs, which are supported by Cisco Software Manager Server (CSM Server).
CSM Server supports a set of finite RESTful APIs. The fir...