Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Sip Account

Hi,

I've bought a Sip account from a Voip Service Provider with the following parameters:

1- Registrar server Ip address,port.

2- Sip User account.

3- Password.

4- Realm.

Which platforms and IOS support this type of authentication?Cisco 827 -4v support this authentication?

Thanks in advance.

8 REPLIES
Silver

Re: Sip Account

The username attribute is included in all AAA records and is the primary means for the billing system to identify an end user. The password attribute is included in authentication and authorization messages of inbound VoIP call legs.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087eb0.html

New Member

Re: Sip Account

All IOS after 12.3.8

Regards Andriy.

New Member

Re: Sip Account

Dear All,

Anyone has the configuration of SIP Account on Router to be used as SIP Trunk?? Please, help me.

CUCM <<<>>>CUBE (SIP Account) <<<>>>> Service Provider.

BR.

Winai

Cisco Employee

Re: Sip Account

This Cisco827 isn't a voice router.  If you're looking for a cheap voice router with a SIP stack, look at a 1751-V.

For the SIP trunk configuration, this document should get you there; configuration depends on what the provider is looking for (i.e. do they want number registration, authentication, etc.):

http://www.cisco.com/en/US/partner/docs/ios/voice/sip/configuration/guide/sip_cg-basic_cfg_ps10592_TSD_Products_Configuration_Guide_Chapter.html

New Member

Re: Sip Account

Dear Sir,

     thank you so much. the SIP provider gave me the user and password with 30 numbers. may it register by number also. How we can set the Router to register 30 sessions for these SIP Account?

BR.

Winai.

Cisco Employee

Re: Sip Account

To register a number, you need to create an ephone-dn or POTS dial-peer with that number.  Then it will be added to the 'sh sip-ua reg status' list.

Typically a provider just needs the main number registered, and then they will send all the calls for your account to that IP.  But each provider may vary.

New Member

Re: Sip Account

Hi Steven,

     Sorry that I am a new one on the SIP Account. it will be very helpful if you please, guide me with the configuration on this topology. Thank in advance.

CUCM <<>> IP-IPGW <<>> 30 numbers of SIP Account.

Best Regards

Winai

Cisco Employee

Re: Sip Account

Winai,

You need to take a look at that document I mentioned earlier in this thread.  I can't just provide you with a sample config, since it is dependent upon your provider's provisioning somewhat.  Also, it's important for you to read the documents so that you learn the proper configuration and how the sIP trunk/CUBE works.

Also look at this document:

http://www.cisco.com/en/US/docs/ios/voice/cube/configuration/guide/vb_book/vb_book.html

Please read through those documents and give the configuration a shot.  If you have specific questions or get stuck somewhere in particular, feel free to post it.

821
Views
0
Helpful
8
Replies
CreatePlease to create content