To map a Q.850 call-disconnect cause code to a different Q.850 call-disconnect cause code, use the q850-cause command in application-map configuration mode. To disable the code-to-code mapping, use the no form of this command.
q850-cause code-id q850-cause code-id no q850-cause code-id q850-cause code-id
The following example maps cause code 34 to cause code 17:
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...