I have enabled a sip trunk between sipproxy and ccm ,the sip phone and sccp phone can call each other.But I have no idea with the two issues as below.
1. I want to use the sip phone to dial the external PSTN number via the MGCP gateway registered in ccm.In the ccm environment,I configure the route pattern as "9.xxxxxxxx",I can call the local PSTN number via the gateway (use sccp phone) .But how can I configure the sipproxy / sip trunk /ccm route pattern to match my requirement?
2.I have two subscribers in the ccm cluster, need I configure two static routes to the two subscriber separately so that the sip phone can call all the phones in the ccm environment ? Does my proxy (version 126.96.36.199) support it ?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...