I am trying to get Outbound Sip calls to work on my CM 6 using a SIP trunk. I am not opposed to using CUBE, but would like to avoid as that will require a router upgrade. Inbound calls work fine. Outbound calls need formatted so that the carrier sees the assigned phone number@public ip address along with a username and password combination. I believe I should be using a SIP Realm for digest authentication and the SIP Security set up for Digest, but I am not sure if I am on the right path or if this is feasible in CM 6 without CUBE. Please let me know what direction I need to head here. Thanks in advance for any help.
Re: SIP Trunk configuration - from field requirements
Sorry i dont have any answers for you..I have a question....I have to configure SIP trunks to a carrier with CM6...i will not be using CUBE either, SIP trunks are delivered over MPLS...i'm looking for a configuration example or link and can only find it for SIP with CUBE
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...