Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SPA2102 Multi-CHannel configuration question

I was hoping that someone would know the answer

to this question.  Is it possible to set up a SPA2102 with one did on port 1, and have

have an additional channel on port 2 that calls can roll to if port 1 is busy?  I have some clients that are

small office home office and only need 2 lines, this is the most inexpensive way to accomplish this.

I appreciate any and all help!

Jim

1 REPLY
New Member

Re: SPA2102 Multi-CHannel configuration question

Jim,

Of course it should be possible but the implementation may depend on your particular setup. You can use call_forward_on_busy feature either within the spa or the softswitch if it is under your control.

Hope this helps.

Greetings

231
Views
0
Helpful
1
Replies