Can you please suggest me what to do to acheive the below setup using Cisco router.
My main objective is to be able to achieve two-stage dialing i.e. dialing into the route using the POTs/PSTN line which would be attached to it, entering the desired telephone number using DTMF, and then having the call sent to our Class 4 softswitch using SIP, for onward termination.
I have been suggested to use either of the below modular access routers with VIC2- 2FXO Card.
Do you think this setup will work. Will I be able to dial into the router by using the PSTN Line attached to it and then after a announcement/beep or any other indication dial the 2nd number which is our desired number and then that number gets routed to our class 4 switch.
Can anyone explain how this setup will actually work?
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...