Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

uBR 924 IOS

Weird problems using a version of IOS on 924.

I've tried 12.1(1)T, etc..

For some reasons, 2 out of 3 924's that I have work with 12.2(3), however, the other one that has 12.2(3) does NOT have dial tone from both FXS ports. not until I load a lower version of IOS, 12.0.5T, can i get dial tone. And even then, that flavor of IOS has problems..

Any suggestions on a Solid IOS for 924's?

tony

1 REPLY
Anonymous
N/A

Re: uBR 924 IOS

If the voice ports on the 924 are going to be used without having the cable interface connected, the following cable interface configuration command should be entered.

cable voip clock-internal

Route(config)#int

Router(config-if)#cable voip clock-internal

This command will generate the clock for the voice components from an internal clock instead of the clock derived from the cable interface.

133
Views
0
Helpful
1
Replies
CreatePlease to create content