I am using Cisco 7960 with MGCP load on it. I am getting one way media for inbound calls when my phone announced 21044 as the UDP source port for RTP stream. My query is how can I change the configuration on my phone to use any other port range other then 21044.
The show config on the phone shows :
start_media_port : 21024
end_media_port : 21044 (I want to change the end_media_port to 21043)
Re: UDP port Configuration on Cisco 7960 MGCP Load
Thanks for the reply. I think you are talking about signaling port the UDP port can be changed in the MGCDefault.cnf file and MACAddress.cnf file. You will find these files on the TFTP server that the phone used to download the configurations.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application Engineered...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?
Cisco Software Manager Server
This document describes the programmatic interfaces, RESTful APIs, which are supported by Cisco Software Manager Server (CSM Server).
CSM Server supports a set of finite RESTful APIs. The fir...