I am trying to regsiter the FXS ports of a VG248 gateway to a cisco callmanager express router runing ios c2800nm-advipservicesk9-mz.124-24.T3.
from the VG248 gateway i can ping the router running callmanager express and vice versa.
this is the configuration on the VG248
ip address 22.214.171.124 subnet mask 255.255.255.224 default router 126.96.36.199
callmanager TFTP server 188.8.131.52
and this is the config on the router running callmanager express
ephone 20 no multicast-moh device-security-mode none mac-address 0BBE.5CB9.D623 max-calls-per-button 2 type vgc-phone button 1:20
telephony-service directory entry 8 2019 name test
I know that to register a port you have to put example port 23 at the end of the Mac address of the VG248 and remove 2 digit from the front, that will be the Ephone mac address on the callmanger express.
when i do a showephone unregistered on the CCME router this is what i get
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...