I tried to send IP Phone caller name which contains UTF-8 characters on a Q.Sig trunk without success.
What I see on my ISDN protocol tester is that CallManager sends the ASCII display name instead of (UTF-8) Display name.
I use CallmManager 5.1, MGCP ISO Q.Sig, 2811 vgw with 12.4 IOS, 7961 type IP Phone.
I of course set the "Transmit UTF-8 for Calling Party Name" checkbox at the E1 port config. I also checked to use the same user locale at the IP Phone and the device pool which is assigned to the gateway.
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?