Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Verify traffic VoFR

Is that anyway to verify if there is any VoFR in the 3640 router?

1 REPLY
New Member

Re: Verify traffic VoFR

Yes you can.

If you're in the enable mode the you can show run and check on the dial-peer voice xxx voip where you will see the session target SerialX YYY.

X is the Serial interface no. and YYY is the DLCI.

dial-peer voice 100 vofr

destination-pattern 4...

session target Serial0/0 100.

You can even issue the following command to verify for vofr : sho dial-peer voice (press enter).

Router1>sho dial-peer voice

VoiceOverFRPeer111

tag = 111, destination-pattern = `111....',preference = 0,

Admin state is up, Operation state is up

DTMF Relay = disabled

type = vofr, session-target = `Serial0 100',

Hope this can help you.

161
Views
0
Helpful
1
Replies
CreatePlease login to create content