Ok, i am stuck. i have a cisco 2620 with a nm-1v, a Vic-2FXO, and a 7940 IP phone. i have inbound calls working, but normally with an analog phone plugged into our phone system, after 6 rings it is supposed to go to our voice mail system, but when someone makes a call into the sip phone, it just rings, rings, and rings, and never goes to voice mail. i acn't find what i am missing. can someone help me out?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...