Hi Almir,
The card is comatible with 1751-4V. The VIC2 cards are the new generation cards. Working wise they are no different. I checked the configs nd they looked kinda incomplete. Usually the FXO works with a "connection plar/trunk". Neither did I notice any voip dial-peers.
Sample config for call flow : (phone---pbx---vic2-fxo---router1--ip---router2---fxs--phone)
voice-port 2/0
cptone BR
connection plar 3000
dial-peer voice 100 voip
destination-pattern 3000
session target ipv4:p.q.r.s
dial-peer voice 1 pots
destination-pattern .T
port 2/0
The above config should be fine for inbound and outbound calls. If this doesn't work please send me the following-
1. Exact call flow eg
2. deb voice ccapi inout
3. debug vpm signal
4. debug vtsp events
5. debug vtsp session
Subhrojyoti