Hi. I have been using for a couple of year VoiP using a 1760 Cisco Router, configured with 2 VIC2-2FXS. Current IOS 12.4(10a). PVDM-256K=
Everything was woking fine during a long time, but just a week ago, the service is not working as it is supposed to work. If somebody from another location dial my Dial Peer number, the routers detects the call, but the phone doesn't ring. If I try to make a call to any dial peer, the router detects the call, I get the Dial Tone, but them I receive a busy tone.
The communication lines are OK, no changes in the configuration were made, just stop establishing the call.
What could be happening?. Maybe an IOS upgrade could solve the problem?. What could cause this behavior?
I have solved this issue. I usually specified the codec in the dial peer definition. For any reason, when the call was established, it was not taking the correct codec. I just deleted the line where I specified the codec and when I try to make a call now everyting is ok.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...