I have and VoIP environment and I would like to implement the "busyout monitor probe" feature to add a new functionality into the network.
My doubt is about the command "busyout monitor probe" timer: anyone know what's the timer value that the probe used to monitor a determined IP address specified in the command?. I mean, what's the period of time that the probe is using to pooling the IP defined in the command using, for example, the ICPIF parameter or other in the command before it decide that the threshold limit was exceeded?.
If the busyout monitor probe command is not entered, the voice port does not monitor SAA probe signals.
If the busyout monitor probe command is entered with no optional keywords or arguments, the default codec type is G.711 a-law, the default loss and delay thresholds are the threshold values that are configured with the call fallback threshold delay-loss command, and the loss of SAA connectivity causes an immediate forced busyout condition.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...